CNC模式

從 ArcoWiki
於 2018年6月1日 (五) 10:03 由 Slia (對話 | 貢獻) 所做的修訂 (创建页面，内容为“'''CNC Mode''' is the state of the CMM that allows automatic movements. The DMIS enhance two different attitudes based on the CNC Mode selected: *MODE/P…”)
(差異) ←上個修訂 | 最新修訂 (差異) | 下個修訂→ (差異)
跳到： 導覽， 搜尋

CNC Mode is the state of the CMM that allows automatic movements.

The DMIS enhance two different attitudes based on the CNC Mode selected:

  • MODE/PROG,MAN: The CMM is in PROGRAMMED mode, the path is determined by the commands listed in the MEAS/ENDMES block and the inspection will be performed following the PTMEAS commands.
  • MODE/AUTO,PROG,MAN: The CMM is in AUTOMATIC mode, if the measuring feature has an canned cycle, then this will be performed even if the MEAS/ENDMES block contains PTMEAS commands.

The custom canned cycles (Non-Dmis standard) enhanced by ARCO, if set, are also executed in AUTO mode.

取自 "https://zh-cn.arcowiki.com/index.php?title=CNC模式&oldid=32"