使用DMIS代码发送变量到输出

This code example is used to send a calculated variable to output applying a tolerance as it was a measured feature.

$$
$$Section 1: Preparing the Variable, this is to be substituted by an actual calculation of the required variable


DECL/DOUBLE,NominalValue,MeasuredValue,Deviation

NominalValue=ASSIGN/10

MeasuredValue=ASSIGN/10.5

Deviation=ASSIGN/MeasuredValue-NominalValue

$$


$$
$$Section 2: Preparing the tolerances


DECL/DOUBLE,utol,ltol

utol=ASSIGN/0.1

ltol=ASSIGN/-0.1

DECL/DOUBLE,oot

DECL/CHAR,200,msg

IF/(Deviation.GT.utol)

oot=ASSIGN/Deviation-utol

ENDIF

IF/(Deviation.LT.ltol)

oot=ASSIGN/Deviation-ltol

ENDIF

msg=ASSIGN/STR(oot,13,4)

$$


$$
$$Section 3: Creating the output string with formatting


DECL/CHAR,500,strOut,strout1

strout1=ASSIGN/'LABEL NOMINAL ACTUAL DEVIATION LOWER TOL. UPPER TOL. OOT'

strout=ASSIGN/CONCAT('DIST ',STR(NominalValue,14,4),STR(MeasuredValue,14,4),STR(Deviation,14,4),STR(ltol,14,4),STR(utol,14,4),msg)

$$


$$
$$Section 4: Sending to Output


TEXT/OUTFIL,strout1

TEXT/OUTFIL,strout

$$